Graco 166215 Nut Packing
$236.73
In Stock
Graco 166215 Nut, Packing secures and compresses the pump’s packing stack to maintain a proper fluid seal. Use when servicing packings or if the nut’s threads are worn—always verify fit in your sprayer’s parts manual.
- OEM replacement for pump lower/throat assembly
- Prevents leakage by maintaining packing compression
- Match by model & pump diagram before ordering
- Install hand-tight first; avoid over-compression
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Overview & Key Details
Compatible Machines
Compatibility for Graco 166215 Nut, Packing depends on the pump assembly. Always confirm via your sprayer’s parts manual or pump breakdown before ordering.
- Graco Ultra / Ultra Max II contractor-grade piston-pump sprayers (selected models)
- Graco Mark-series high-output texture/paint sprayers (selected models)
- Graco LineLazer and TexSpray industrial-duty units using compatible pump stacks (selected models)
What This Part Does
The packing nut retains and compresses the pump’s packing stack around the piston/rod, maintaining a fluid seal, controlling leakage, and ensuring smooth pump operation. It is replaced when threads are damaged, adjustment runs out, or after major packing service.
Quick Facts
| Part Number | 166215 |
|---|---|
| Part Type | Packing Nut (pump/throat assembly component) |
| Typical Location | Pump lower – secures/adjusts the packing stack on the piston/rod |
| When to Replace | After packing overhaul, visible thread damage, or inability to maintain seal without over-tightening |
Fit & Identification Tips
- Match by model number and pump assembly drawing; confirm the packing stack and nut reference numbers in the manual.
- Do not substitute by size/appearance alone—different Graco pumps use different nut geometries and threads.
- On reassembly, tighten only enough to stop seepage; over-compression shortens packing life.
Frequently Asked Questions
Open your sprayer’s parts manual, locate the pump lower assembly diagram, and confirm the packing-nut reference number equals 166215. If unsure, cross-check your sprayer’s full model/series and serial range against the official parts list.
Clean threads, lightly lubricate per manual, and hand-start to avoid cross-threading. Tighten gradually until seepage stops during test spray. Recheck after first use—new packings may settle and need a minor readjustment.
Reuse is acceptable only if threads and sealing faces are undamaged. Many techs replace the nut whenever doing a full packing rebuild to ensure proper adjustment range and reliability.
No reviews yet. Be the first to review this product!
