Graco 101579 Pin
$13.50
In Stock
Graco 101579 Pin is a genuine OEM roll pin used to secure internal linkages in Graco pumps, ensuring reliable alignment and performance.
- Part Type: Roll/Retaining Pin
- Size: 1/8" × 3/4" (3.2 mm × 19 mm)
- Used In: Fire-Ball 300 & President Pump series
- OEM Quality: Genuine Graco replacement part
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Compatible Machines — Verified
- Graco Fire-Ball 300 (5:1 ratio) — selected oil pump models (e.g., 203-872, 203-857, 204-254, 222-087)
- Graco Fire-Ball 300 (15:1 ratio) — models such as 206405 (Series K) and related series sizes
- Graco Fire-Ball 300 (50:1 ratio) — grease pump variants and packages (various model sizes)
- Graco President Pump (with Priming Piston) — various models that list 101579 in the parts diagram
Product Overview
Graco 101579 Pin is a genuine OEM roll/retaining pin used to secure internal linkages (shafts/rods) in Graco pump assemblies. It helps maintain alignment and prevents drift or loosening under load.
Key Specs
| Part Number | 101579 |
|---|---|
| Type | Roll Pin / Retaining Pin |
| Nominal Size | Approx. 1/8 in. (3.2 mm) diameter × 3/4 in. (19 mm) length |
| Typical Location | Pump drive/linkage areas (e.g., connecting rods, levers) on Fire-Ball 300 and President families |
| Genuine/OEM | Yes — Graco original replacement hardware |
Why Choose OEM?
- Correct fit to factory tolerances for pump longevity
- Reliable retention under vibration and cyclical loads
- Fast maintenance—direct swap using standard pin drivers
Installation & Fit Notes
- Match the pin in your parts diagram (look for ref. “101579”).
- Inspect mating holes/bores; replace worn components to ensure tight fit.
- Drive the roll pin squarely; avoid flaring ends which can hinder service.
Frequently Asked Questions
Yes—if your model’s parts list calls out 101579. The pin is used across many Fire-Ball 300 (5:1, 15:1, 50:1) and President pumps, but always verify against your unit’s serial/series diagram.
You may see linkage misalignment, premature wear, and reduced pump performance. Replacing with the correct OEM pin restores proper retention and smooth operation.
Roll pins are press-fit; no torque value is applied. Use an appropriate drift/punch and ensure bores are clean and to spec before installation.
No reviews yet. Be the first to review this product!
