Name: Graco 054739 Tube Pvc Rd
Brand: Graco
SKU: 054739
Price: 7.40 USD
Availability: InStock

Graco 054739 Tube PVC RD — OEM Round PVC Tube (0.625" OD)

Compatible Machines

Official model-specific compatibility is not published by Graco for this generic tubing part.

Use your sprayer’s parts manual to confirm fit wherever a 0.625" OD PVC round tube is specified (internal fluid/siphon/return routing). If your manual lists 054739, this is the correct OEM replacement.

Check your exact model’s exploded parts diagram for part 054739.
Match required outside diameter (0.625"), material (PVC), and round profile.
Verify length/end-connection requirements for your unit’s routing.

Product Summary

The Graco 054739 Tube PVC RD is a genuine OEM round PVC tube designed for internal fluid handling on select Graco airless sprayers. Its 0.625" OD sizing supports leak-resistant routing in manifolds and fluid lines when the parts manual specifies this tube.

Key Specifications

Part Number	054739
Description	Tube, PVC, RD (round profile)
Outside Diameter (OD)	0.625" (5/8")
Material	PVC (polyvinyl chloride)
Typical Use	Internal fluid routing (manifold/tubing harness/return paths) on airless sprayers where 0.625" OD PVC tube is specified
Fitment	Model-specific. Confirm with your sprayer’s parts manual.

Why Choose Genuine OEM

Correct 0.625" OD and material spec for listed assemblies
Optimized internal routing for consistent fluid delivery
OEM quality for reliable sealing when properly installed

Installation Tips

Power down and follow pressure relief procedure per your manual.
Measure the required run; cut cleanly with a sharp tubing cutter (deburr ends).
Match orientation and end connections per the diagram; avoid kinks and tight bends.
After installation, perform a leak check at low pressure before full operation.

Frequently Asked Questions

Compatibility is model-specific. Check your sprayer’s parts manual or exploded diagram—if it lists 054739 (or “Tube, PVC, RD, 0.625" OD”), it will fit that location. If your manual lists a different OD or material, use the specified part instead.

Confirm the outside diameter (0.625"), material (PVC), required length, and the type of end connection (clamp, barb, push-fit). Match your manual’s specification and routing path.

PVC is widely used but not universal. Verify chemical compatibility with your coatings/cleaners. For aggressive solvents, your manual may specify alternative materials—always follow the OEM specification.

Yes—cut to the length shown in your parts diagram. Use a clean, square cut and avoid crushing the tube. Re-install clamps/fittings exactly as specified to prevent leaks.

Internal routing tubes typically see low to moderate system pressures compared to the high-pressure hose. Always operate within your sprayer’s ratings and use the tube only where the manual specifies 054739. If unsure, consult a Graco-authorized service center.

Graco 054739 Tube Pvc Rd