Graco 257146 Pump Replacement
$1,764.00
$2,100.00
Save 16%
In Stock
The Graco 257146 Pump Replacement is a genuine OEM fluid section designed for IronMan sprayers, ensuring restored performance and pressure consistency.
- Fits IronMan 300E (256655)
- Fits IronMan 500G (256790)
- OEM quality for durability and safety
- Ideal for fixing low pressure or pump wear
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Overview: Graco 257146 Pump Replacement (Fluid Section)
Compatible Machines
- IronMan 300E (Model 256655)
- IronMan 500G (Model 256790)
What is the Graco 257146 Pump Replacement?
The Graco 257146 is an OEM fluid section (pump) assembly designed to restore pressure and flow on compatible Graco IronMan series sprayers. It replaces the worn internal pump components so your sprayer maintains consistent output, proper priming, and factory-rated performance.
- OEM quality: Direct-fit replacement for reliability and safety.
- Complete fluid section: Replaces the critical high-pressure pumping module.
- Performance restoration: Resolves low pressure, pulsation, and leakage caused by wear.
Specifications & Details
| Part Number | 257146 |
|---|---|
| Type | Fluid Section / Pump Replacement (sometimes referenced as “Fluid Pump E”) |
| Series Compatibility | IronMan series (see list above) |
| Included | Factory-assembled pump section (use your sprayer’s manual to confirm included seals/fasteners) |
| Origin | Genuine Graco OEM component |
When Should You Replace the Pump?
- Chronic pressure loss or inability to reach spray pressure
- Visible fluid leaks from the pump section
- Pulsation, surging, or poor atomization despite clean filters/tips
- Excessive wear on piston/cylinder components noted during service
Frequently Asked Questions
Yes. It is compatible with IronMan 300E (256655) and IronMan 500G (256790). Always verify your exact model/serial and pump style before ordering.
257146 is the fluid section (pump) assembly. If you only need seals, check your sprayer’s parts list for the correct packing/seal kit number instead.
Basic hand tools typically suffice. Follow Graco service steps: perform the pressure-relief procedure, disconnect power, remove the old section, transfer any required fittings, torque fasteners to spec, then prime and test for leaks.
In many cases, yes—if caused by internal pump wear. Also check and clean filters, confirm tip size is within spec, and rule out suction/air leaks or worn packings.
The confirmed fit is for IronMan 300E and IronMan 500G. For other models, consult the official parts list or contact support with your sprayer’s model and serial number.
No reviews yet. Be the first to review this product!
